Case Studies:


Process Heating Systems
The Challenge: An engineering firm needed freeze protection for eight large contaminated water tanks at a waste remediation site in the northern U.S.
Our Solution: The temperatures were dropping and time was running out to get tank heaters on site to prevent freezing. We swung into action with several design proposals. The customer selected and ordered four re-circulating heater / control panel skid systems. However, they needed these systems designed, built and shipped within 2 weeks! To save time, the customer decided to use on site pumps and piping to connect and operate the systems, instead of incorporating this into the skid package.

Return to Top
FAIL (the browser should render some flash content, not this).

Advance Industrial: Get A Quote

Whether you need a temperature sensor, electric heater, or temperature controller, Advance Industrial can be your custom solutions provider. We understand the importance of partnering with you and your team to maximize value and provide low cost of ownership through design and performance. When you take advantage of our engineering process, you enlist a team of experts that become part of your design process. Best of all, because Advance Industrial's supplier remains a vertically integrated American manufacturer, the custom thermal solutions we design are engineered, prototyped, validated, manufactured, tested and delivered from our factory to your location.

Complete the following online form to Request a Quote from Advance Industrial.

IMPORTANT: Required fields are marked with an asterisk (*)
*Your First Name:
*Your Last Name:

Please provide one of the following for us to reach you:
Your Phone Number: ()
Best Time(s) to Call:
*Your Email Address:
Questions & Comments:
Attach File:
♦
Case Studies:


Beverage Manufacturer
The Challenge: A beverage manufacturer used several large fill and seal lines to manufacture drink pouches. However, the production lines were encountering problems with heater failures on the sealing dies, thus causing them to get shut down. This, in turn, resulted in a large loss in revenue.
Our Solution: We investigated the situation and discovered that the heater leads were weakening and breaking due to the rapid movement of the sealing head and vibration found in the equipment. We recommended a switch from pin leads to swaged-in flexible leads. We also suggested they affix the leads in a stress-relieved configuration in order to further remove stresses and strains from the lead wire to heater connection point.

Return to Top